R2GATE: Anchor Kit AnyRidge

R2GATE: Anchor Kit AnyRidge

For an edentulous case or free end case, the R2GATE Guide™ is fixed with Anchor Pins specially designed for stability of the R2GATE Guide™.

How to use the Anchor Kit?

Case 1. When it is possible to get stability from neighboring teeth (no need to use the Anchor kit)

Place the R2GATE Guide™ by placing it onto the neighboring teeth.

Case 2. When it is hard to get stability from fully edentulous case or neighboring teeth.

1. Fix the R2GATE Guide™ temporarily by asking patient to bite the R2GATE Guide™ using a resin or other tools.
2. Please use the Pin that R2GATE™ program selected, and place that Pin on the Driver Tip.
3. Insert the Pin into the R2GATE Guide™ that the patient is biting, and turn it into clockwise to fix the R2GATE Guide™ to bone.
*Make a hole on the Guide using Ø2.0 Drill if a density of the bone is high. Then, insert the Anchor Pin into the hole.

Case 3. When it is necessary to re-implant a fixture after separating the R2GATE Guide™ OR when the stability of the R2GATE Guide™ is weak even though all planned Anchor Pins are used (This is only for the cases with edentulous jaws and implantations of three or more fixtures).

* Cases for re-implant a fixture after failure
1. Check the condition of an implanted fixture after a separation of a R2GATE Guide™. Evulse the fixture when the implantation is considered as a failure for lack of stability or a path is naccurate.
2. Replace the R2GATE Guide™. Insert the R2GATE Guide™ Anchor to the R2GATE Guide™ Hole of the neighboring fixture, and place the R2GATE Guide™ by turning it into clockwise.

* When it is hard to get stability of the R2GATE Guide™ by an Anchor Pin only
1. When the stability of a fixture by an Anchor Pin only is low, start an implantation from molar areas. Then, connect the R2GATE Guide™ Anchor with an installed fixture to increase stability.